Raised edge conveyor belt loop
Circular conveyor belt refers to the process of production will be made without a joint circular conveyor belt conveyor belt, the belt core strength joint can reach 90% of tape body strong, belt has no obvious joint surface imperfections, therefore, tape transport balance, use small elongation. Our company can produce according to customer need appropriate length, width and thickness of the ordinary type, heat (120 oc) or less, hardy (not less than 40 oc), acid and alkali resistant, high temperature resistant type (no higher than 150 oc) and health circular conveyor belt. Product features: Tilt, raised edge conveyor belt loop can be horizontally, vertically and variable direction Angle of conveying a variety of bulk materials, coal, ore, sand, or chemical fertilizer, food and so on. Below 400 mm size granularity unlimited, throughput can be from 1 m 3 / hour to 6000 m3 / h optional. Can make all kinds of bulk materials to continuous transmission, 0-90 degrees in any Angle with transport large dip Angle, wide applicable scope, cover an area of an area small, no transshipment point, bue to reduce construction investment, low maintenance cost, etc. Solved the not ordinary conveyor belt or conveying Angle pattern conveyor belt can't reach. Raised edge conveyor belt waveform can be used according to the environmental requirements, designs a set of complete conveyor system, you avoid the continuous conveying and complex transmission system. Baseband requirements: Raised edge conveyor belt loop baseband requirement of tensile strength and abrasion resistance. Raised edge conveyor belt with free to leave the edge of the wave, in order to adapt to the request of the Angle to the, belt longitudinal have softness, lateral requires certain rigidity. Company produces wavy guard conveyor belt adopts special structure lateral rigidity of the baseband, solve the large size belt with collapse phenomenon in the return process. The structure of the baseband: Baseband is covered in rubber, under cover rubber, core and lateral stiffness layer of four parts. Cover the rubber thickness on for 3-6 mm; Under cover the adhesive thickness 1.5 4.5 mm, with core materials under tension, its material can be cotton canvas (CC), nylon (NN), EP canvas (EP) or just a rope (ST). In order to increase the transverse rigidity of the baseband, on the core on the body, if special strengthening layer, called lateral stiffness layer. The width of the baseband specifications, same as the common adhesive tape, accord with GB7984-2001 standard. Scope of application: Raised edge conveyor belt loop widely circulated and port, metallurgy, mining, electricity, coal, foundry, building materials, food, fertilizers, and other fields material transfer.
